|
Before You Sew, Knit, Crochet, or Quilt - Fabric and Yarn Preparation
Swift Yarn Winder Yarn Ball Winder Yarn Ball Winder
|
Before You Sew, Knit, Crochet, or Quilt
|
||||||||||||||||||||||||||||||
Preparing Fabric for Sewing or Quilting Pre-washing and straightening fabric before sewing is a very important step to prevent shrinkage in a garment or quilt and affects the “drape” of a garment. Pre-washing removes the sizing added to fabrics in the milling process and helps to align the fabric grains. Pre-washing also shrinks fabric and pre-washing removes any excess fabric dyes. |
|
![]() |
Before pre-washing, straighten the ends of the fabric by either tearing across the grain or by pulling a thread across the grain. On fabrics that will tear, simply clip the selvedge and tear the fabric across the width of the fabric. Overcast the ends with a zigzag or serger before washing. On fabrics that will not tear, such as a soft or loosely woven fabric, wool, or heavy denim, |
clip the selvedge and gently pull a crosswise thread to the other selvedge. Cut along the pulled thread. On a woven plaid, cut along a crosswise thread at the edge of a plaid line. Overcast the ends with a zigzag or serger before washing. |
|
![]() |
To re-align the grain, fabric may need to be stretched into place. Place damp fabric on a grain board and align the lengthwise (weft) and crosswise (weft) threads at 90-degrees angles by stretching the fabric into place. Allow the fabric to dry or press. |
Setting Dyes
If the colorfastness of a fabric or yarn is questionable, soaking it in a bucket of cold water with a handful of salt before washing them for the first time. Hot water and vinegar can also be used in place of the salt and water. Author’s Note: I ’ve had natural dyes run when washed – check your labels and test for color fastness. To test for colorfastness, dip a piece of yarn or fabric in water, lay it out on a white paper towel to dry. If color transfers to the paper towel, the yarn or fabric will bleed. To color set a fabric or yarn, soak it in water with either salt or vinegar – I’ve had success with both. Preparing Yarn for Knitting or Crocheting |
|
![]() |
To make yarn hanks, set up an umbrella swift (see drawing at left) and attach yarn end to the swift spokes. Turn the swift, winding the yarn onto the swift spokes. At the end of the yarn, loosely tie together the two yarn ends. With scrap yarn, tie around the yarn hank in 3 or 4 places. Remove yarn hank from the swift. |
Launder yarn hank and dry. Place the dry yarn hank back onto the swift. Cut of the securing scrap yarn pieces and untie the two ends. Place one yarn end onto a ball winder (see drawing at lower left) and wind yarn into a ball. |
|
![]() |
If a swift is not available, yarn may be wrapped around the backs of two chairs forming a hank. If a ball winder is not available, yarn may be wrapped by hand into balls. |
copyright © MM, C.W. Carvalho. ALL RIGHTS RESERVED. This material is not for sale or reproductions without the written consent of the author. Do not copy or post to another web site.
![]() |
![]() |
![]() |
![]() |
![]() |
![]()
